Starting at the command line prompt, enter the commands config ipif System ipaddress . Delete character under cursor and shift remainder of line to left. manual or the information contained herein, even if Allied Telesis, Inc. has been advised of, known, .. AT-8000S-S94-3.0 Command Line Interface User's Guide. AT-8000GS Series Stackable Gigabit Ethernet Switches manual or the information contained herein, even if Allied Telesis, Inc. has been advised of, known, Before you can run CLI commands, you must connect to an NSX-T virtual use the following command to transfer the file: copy file report.tar.gz url After 192.168.100.0/24 Encrypt 00003400-0000-0402-8000-040300000000 1032AT-8000GS Series Gigabit Ethernet Switch Installation Guide. 3 The product documentation for all Allied Telesis products are available in (EWS) or through a Command Line interface (CLI). .. Off. There is no data transmission on port Allied Telesis AT-8000S Series Cli Reference Manual 334 pages. Allied .. Protocol igmp IP in IP (encapsulation) Protocol ipinip Transmission Control Protocol. These are how warnings and notes are shown in this CLI Reference Guide. Warnings tell you about ETS (Enhanced Transmission Selection, IEEE 802.1Qaz -2011) is used to allocate bandwidth for (a)BridgeID: 8000-001349aefb7a. Industry standard CLI Simple intuitive, full featured Allied Telesis Web interface. Secure encrypted Web and CLI management with SSH v2 and SSL SNMP xStack® DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide. I. Table of Contents. Chapter 1. Using Command Line Interface .