24 BayStack T-PWR Switch Overview - 23 Power Sharing Options Any combination of the following can be selected: -AC Power of BayStack 460 -BayStack 10 Power Supply Unit* 2 -pin cable required - AL -Network Energy Source (NES)* The BayStack 460 can be used in conjunction with the For sale Nortel BayStack 460-24T-PWR 24-Port POE Switch BPS2000-2GE SFP Expansion Module. Unboxing of the Nortel 5520-48t pwr poe Power standard: 802.3af up to 15.4 volts, can power up phones, access points i lost the access of Nortel 5520-24t-PWR Routing Swtich, i can't access through web nor to console, can anyone tell me how to Reset the Switch to Factory Default from UI Button in Front of the Switch.. I've been working on a Nortel Baystack 450-24T with Firmware at V1.47 and Software at v3.1.0.22. To factory restart i believe i need a serial cable (which i dont have) and use putty This would also change the back to default IP, 192.168.192.168, would the switch stil work at L2, if my lan is at 192.168.1./24? Nortel BayStack 5520-48t-pwr hardware reset. 3 posts. Mordac. I have not used a 5520, but typically the Nortel serial is null modem adaptor different from the Cisco console cables. There should be 4 ways into a 5520: console cable, telnet, webpage and JDM, if you can get in by any one of them 24 100BaseFX ports (MTRJ connector) plus 2 10/100/1000 SFP combo ports Redundant power slot for DC/DC converter installation. 24 10/100BaseTX RJ-45 ports with PoE plus 2 10/100/1000/SFP combo ports Integrated redundant power connector for RPS 15 cable Connection. • 5520-24T-PWR(config)#interface fastEthernet all o 5520-24T-PWR(config-if)#poe poe-shutdown port. You should use the Maximum resource sharing setting: • If you are using your 5520 for big file transfers (like backup of servers).