tions. In most cases a toggle should be fitted between the Furlex stay and the forestay attachments. Forestay attachment on masthead rigs:Always connect the stay with a toggle to give full articulation. Forestay attachment on fractional rigs, Seldén type: 505-018 ø 6 &7 mm wire: Connect with an eye/fork-tog-gle. The latest generation of this well-made furling system strike a balance between total cost, performance, and versatility. It the easiest system to install yourself—complete with step-by-step video.Combined with the included forestay, which is a recommended upgrade for any furling system unless your boat has recently been re-rigged, and the Furlex is the best value of any furling system Contact number +1 727-490-9553 Address The Yacht Rigger Salt Creek Marina 107 15th ave SE St Petersburg, Fl, 33701 I have a Furlex Type C jib furler on a 16m x 10mm 1x19 headstay. The thing that holds is all together is part B5, a tube with a thread on the end that screws into the top of a Selden modified Sta-Lok Furlex Type C - Cruisers & Sailing Forums Manual for assembly and operation Furlex 400 S & 500 S 595-116-E 2008-02-04 400 S & 500 S 2 This information must be followed to avoid damage to the system and the risk of personal injury. The 5-year guarantee on the Furlex-system is only valid if the system is assembled and operated correctly according to the manual. Manual Furlex 200 S & 300 S 595-104-E 2007-01-15 200 S & 300 S 2 1.1 The manual To derive the maximum benefit and enjoyment from your Furlex-system, we recommend that you study this manual carefully. The manual is divided into two sections, one dealing with ASSEMBLY and one with OPERATION. Each section contains references to the other. The manual covers two different Furlex sizes, 400 S and 500 S. The Furlex 400 S is designed for use with a 12 or 14 mm forestay, while the 500 S system is designed for a 16 mm forestay and has a stronger luff extrusion and halyard swivel. The assembly procedure for the 400 S and 500 S differs in some respects. Whilst we are on the subject of Type B mark 2, I am replacing the headstay but cannot get the cone out of the staylock fitting. The manual, Selden/furlex is available online. It is best to have a complete understanding of the system. I was able to clean and reuse balls and races by using a good grease to hold them in place for reassembly The manual covers four different Furlex sizes, 200 S, 300 S, 400 S and 500 S. The assembly pro-ceedings varies on some points between the different sizes. This is marked in the manual. The model designation can be found on the line drum top. All dimensions specified in the manual are in millimetres (mm) unless otherwise indicated. Furlex is manufactured by Seldén Mast, the world's leading manufacturer of masts and rigging systems. 1.2 Product information Follow the instructions carefully when fitting. 5 1. Forestay /eye terminal 2. Top guard 3. Halyard swivel 4. Snap shackle 5. Luff extrusion 6. Distance tube 7. Joining sleeve 8. Sail feeder 9. Sail feeder connector 10. The manual covers one Furlex size, 100S. The model designation can be found on the line drum top. Furlex is specified and manufactured using Metric dimensions. To assist owners unfamiliar with The Torx type socket has an excellent grip but is not yet in common use. A Torx spanner set is included with the Furlex. The Torx socket sizes are: Manual Furlex 100 S 595-102-E 2008-05-02 100 S. 2 1.1 The manual To derive the maximum benefit and enjoyment