General • This manual has been authored with simplified grammar, to meet the needs of international us- ers. • The operator of this equipment must read and follow the descriptions in this manual. Wrong op- eration or maintenance can cancel the warranty or cause injury. • Do not copy any part of this manual without written permission from FURUNO. NavNet CAT5 Cable Installation Steps: A. Pre-Wire the NavNet Installation with CAT5 or CAT5e Cable. Crimp Male RJ45 Connectors to each end of the CAT5 Cable in a "Straight" Wiring Configuration. Run CAT5 from each Display or Network Sounder in the NavNet to the location where the hub will be mounted. furuno.com Model PRODUCT NAME: RADAR SENSOR i IMPORTANT NOTICES General • This manual has been authored with simplified gr ammar, to meet the needs of international users. • The operator of this equipment must read and follow the descriptions in this manual. Wrong oper- ation or maintenance can cancel the warranty or cause injury. Prepare a cutout in the mounting location by using the template sheet supplied as the installation material. 2. Fix the display unit by six washer head screws M4x20. Refer to the outline drawing at back of this manual. 335+1 6-R2.25 342+0.5 217+0.5 140+0.5 4.5 209+1 Flush mounting of display unit INSTALLATION 1.1 Installation Considerations • Do not paint the radome, radar wave emission may be affected. • Do not select a location that allows water to accumulate at the base of the sensor. • Do not cut power/LAN cable or cable assembly when installing. • Do not block air vent at the bottom of radome. Connect to a distribution switchboard 2. DP-6 To change the system setting and conduct self-test, refer to the Operator's Manual OME-5610. 3. FELCOM 12 To carry out log-in and set the system setting, refer to Installation Manual IME-5613 and Operator's Manual OME-5613. 4. DSC-6 To set the system setting and conduct self-test, refer to the Operator's Manual and Installation Drill four pilot holes in the mounting location for mounting bolts (M6 ×20, supplied), referring to the outline drawing at the back of this manual. 2. Screw two hex head slot bolts into the lower pilot holes. Leave 5 mm of thread vis- ible. 3. Set the notches of the unit onto the screws fastened at step 2. 4. Installation Materials CP65-00900 000-029-047 1 set w/CP65-00901, CP65-00902, CP65-903 Optional equipment Digital Indicator (000-029-020) Name Type Code No. Qty Remarks Digital Indicator DS-830 - 1 Spare Parts SP65-00601 002-889-730 1 set Fuse Accessories FP65-00400 000-029-028 1 set FP65-00401, FP65-00402, FP65-00403 Installation Materials 1.1 Installation of Multi Function Display The TZT12F is designed to be mounted in a console or panel, or mounted on a desk-top. The installer of this equipment must read and follow the descriptions in this manual. Wrong installation or maintenance can void the warranty. Mounting considerations GPS antenna unit Install the GPS antenna unit referring to the drawing on page D-5 or D-6 at the back of this manual. When selecting a mounting location for the antenna, keep in mind the following points. furuno.com All brand and product names are trademarks, registered trademarks or service marks of their respective holders. The paper used in this manual is elemental chlorine free. ・FURUNO Authorized Distributor/Dealer 9-52 Ashihara-cho, Nishinomiya, 662-8580, JAPAN Installation Materials CP05-13701 001-426-520 1 For DS-8500 We have 3 Furuno FA-100 m